Looking for Answers about this Product?

Customer questions and answers for
Bonded Logic Heat/Sound Insulation

HEAT/SOUND INSULATIONProtect your vehicle using the same technology developed by NASA to protect its spacecraft!Lightweight aluminum foil facing reflects 97% of unwanted radiant heatAbsorbs n
Customer questions and answers:
23 Questions
 | 
12 Answers
Overall rating:
4.674 out of 5
4.7
out of
5
Shop now

Customer questions and answers for Bonded Logic Heat/Sound Insulation

Question
Manufacturer
Is this a product manfactured by Bonded Logic, and is it suitable for insulating living quarters in an RV? If good in an RV, should it be installed directly to an inner or outer surface or have free airspace each side to obtain maximum benefit?
asked 6 years, 6 months ago
by
JAScar
texas
on Heat/Sound Insulation
1 answer
Answers
answer 1
This product is indeed manufactured by Bonded Logic. It's most effective if installed between the outside and inside wall similar to normal housing insulation but you can also install it over an inside wall if you need to.
Staff Answer
Expert Answer
answered 5 years, 10 months ago
by
ProductSpecialistBrian
Question
We have a diesel pusher motorhome. Is this product recommended to line the walls of the engine compartment?
asked 5 years, 9 months ago
by
Vagabond94
on Heat/Sound Insulation
1 answer
Answers
answer 1
yes you can use this on your motorhome. will work may need the bulk roll to have eoungh.
answered 4 years, 7 months ago
by
Anonymous
Question
Usage under carpet in vehicle
Is there One side foil, or two?
1. Used under carpet should foil side be up or down if only one sided?
2. Two part question. Will this product provide a noticable dampening of noise, and noticable abatement of heat installed under the carpet in the interior of a vehicle?
Thank you!
JHF
asked 5 years, 9 months ago
by
JHouston
Central Florida
on Heat/Sound Insulation
1 answer
Answers
answer 1
one side, foil down or toward the heat,,, yes,,,very good product, heat and noise
Greg
Top 250 Contributor
Top 250 Contributor
answered 5 years, 8 months ago
by
Anonymous
Monticello, Ky
Question
Re: SKU 1JA268586. When installing in an automobile on the firewall or floor, does the reflective coating go toward the inside or outside?
asked 4 years, 5 months ago
by
Anonymous
on Heat/Sound Insulation
1 answer
Answers
answer 1
towards the heat source, so in your case the foil is facing the firewall
answered 4 years ago
by
Anonymous
Question
Is this material sticky on the back side so I can stick on to the fire wall?
2002 GMC serria
Year: 2002
Make: GMC
Model: Serria
asked 4 years, 4 months ago
by
Anonymous
on Heat/Sound Insulation
1 answer
Answers
answer 1
No, it must be applied with spray adhesive glue
answered 4 years ago
by
Anonymous
Question
What is size?
What are measurements of item?
asked 3 years, 8 months ago
by
Anonymous
on Heat/Sound Insulation
1 answer
Answers
answer 1
4'x24'x1/2"
answered 10 months ago
by
Gearhead
Question
Foil on one side only?
I have a 1995 Ford Cargo Van to insulate. I have heard that the foil against metal can cause corroision. If that is true, wouldn't I want the foil side facing inward and and the cloth side glued to the van walls?
asked 4 years, 5 months ago
by
Anonymous
on Heat/Sound Insulation
1 answer
Answers
answer 1
Since your van is (probably) painted, and you'll put a layer of adhesive, you shouldn't have to worry about corrosion.
I would hope that it was covered on both sides (for both cold weather and hot).
answered 4 years, 1 month ago
by
Anonymous
Question
how do you install, do I take carpet out, isn't that hard?
2010 ram truck 1500 4.1ltr
asked 4 years, 2 months ago
by
Anonymous
on Heat/Sound Insulation
1 answer
Answers
answer 1
Carpet removal isn't all that hard. The seats are probably the most labor intensive thing. Sill plates, kick panels and any trim pieces that touch the carpet typically come out, then the carpet lifts out.
answered 11 months ago
by
jbro
TX
Question
What's the size
asked 4 years, 1 month ago
by
Anonymous
on Heat/Sound Insulation
1 answer
Answers
answer 1
Click on the Select Options button.
answered 4 years, 1 month ago
by
Anonymous
Question
Can this product be used for marine application?
asked 3 years, 10 months ago
by
Anonymous
Home
on Heat/Sound Insulation
1 answer
Answers
answer 1
I used it to insulate my sailboat and engine compartment for the winter. It's definitely better than nothing, and it conforms to the hull much better than foam. if your boat leaks, then it doesn't really matter that it's mildew resistant. I only wish the foil were on both sides. SailorDan
answered 10 months ago
by
SailorDan
Fort Washington, MD, USA
1 2 3 next>>
Shop now