this would be available via special orders at JCW. please contact an inside representative regarding special ordering this part.

kits # zx222903, zx266137, zx266144 will fit your car as an off-road only application, assuming your vehicle has standard long tube headers with 3" collectors.

these systems are only for vehicles with standard full length headers and a V8. you can get them to fit if you can fabricate or have the down pipes off of the manifold fabricated to fit the vehicle. these systems go up to where long tube headers would bolt up, which is about where your cross member is.

No

exit is straight out the back. the system tucks up in the rear, then angles down to get in under the bumper. the tail pipes run along side the leaf spring. i do not have available front pipes to hook up to factory manifolds for this application.

Please see the included link for the exhuast for your application
http://www.jcwhitney.com/HEARTTHROB-HEADER-BACK-DUAL-EXHAUST-KITS/GP_2010448_N_111+1974+200729775+600001711_10101.jcw?showCustom=1

i do, but this section refers to header equipped dual exhaust systems. we do have manifold back systems for non-catalyst equipped vehicles in another section. to get these header dual systems to fit manifolds would require cutting and welding to make tubes from your manifold to about the cross member.

Please see below image for exit points

no, this kit is only for vehicles equipped with standard aftermarket headers with 3" collectors. the kit itself will still fit your vehicle, but you would need to hook up (cut, weld, bend, fabricate) some down tubes to get to where the headers would exit if you want to stick with manifolds. if you are having a muffler shop install this kit, they should be able to bend you some down pipes.

i can answer where the exhaust exits. it exits in the rear just under the bumper, it curves down slightly for clearance. on this kit with the 3", there is a lip on the rear quarter panel that often needs to be tugged out slightly for clearance.