Looking for Answers about this Product?

Customer Questions & Answers for
Cyberdyne CYBERDYNE™ ELECTRONIC LED DIGITAL TRANSMISION OIL TEMPERATURE GAUGE

Large Red or Blue LED readout against black is easily visible even in direct sunlight Sender sold separately (ZX470271) Display blacks out completely when ignition is off?no visible logos, legend
Customer Questions & Answers:
2 Questions
 | 
1 Answer

Questions & Answers for Cyberdyne CYBERDYNE™ ELECTRONIC LED DIGITAL TRANSMISION OIL TEMPERATURE GAUGE

Question
Need troubleshooting
The 1st digit on the Trans Temp gauge intermitently stops displaying. On at start up. Within 5 minutes, 2 segments stop displaying. Where can I go for assistance. Silly to spend another $41 to replace a month old device! Thank you
asked 1 year, 8 months ago
by
Fife
 - Brick, NJ
on CYBERDYNE™ ELECTRONIC LED DIGITAL TRANSMISION OIL TEMPERATURE GAUGE
1 answer
Answers
answer 1
Make shure you have a full 12.5 Vdc to 14 Vdc at all times to the gauge power input. Assuming power source is correct, troubleshoot as follows:
a. Disconnect sender wire, either end.
b. Turn on power to gauge.
c. If no fault is displayed after time, fault is probably in the sender or its wire connection to gauge.
d. If a fault displays with or without sender connected, the gauge is faulty. The gauge should have a warranty. Have it replaced under warranty with a letter describing problem.
answered 1 year, 6 months ago
by
TechWriterPro
 - Silicon Valley
Question
Where does the temperature sensor plumb into the transmission?
1991 GMC with 4.3 liter with a 700R transmission.
asked 1 month, 3 weeks ago
by
Anonymous
on CYBERDYNE™ ELECTRONIC LED DIGITAL TRANSMISION OIL TEMPERATURE GAUGE
0 answers
Answers
This question currently has no approved answers.
1 of 1